Uniquely ours! Our model #432 is the only masonry bay window fireplace
in the industry. It has the same features and benefits as our other
masonry fireplaces, but has a larger burn area for an even more
impressive display of flame.
130,000 Btu's
73% efficiency
Black, Air-Seal, Square Cast Iron Doors (4)
10" Clay Flue Adaptor
6" Outside Air Flex Pipe
Borofloat Safety Glass ( (2) 14" x 15")
Chimney Damper Control
Combustion Air Damper Control
Adjustable Legs (for leveling unit)
Bay Lintel Iron & Support Legs
Black Upper & Lower Grills
Brass Upper & Lower Grills
Face Trim - Brass
Door Trim - Brass
Brick-in Fan w/ Variable Speed Control (450 CFM)
Outside Air Vents (closure & nonclosure)
Ash Chute & Cover
Outside Clean Out Door (for ash dump
Top Plate w/ Precut Ctr Hole/Straight Wall-Recessed Mantel
10" Round Stack Pipe - Straight
5", 10" & 14 1/2" Offset Stacks
10" Round Metal Chimney Adaptor for use with 10" HT, Class "A" Metal Chimney
From Unit Sides to Face brick: 3/8"
From Unit Top to Face Brick: 1/2"
From Unit Back/Sides to Block Enclosure: 4"
From Block Enclosure to Exterior Walls: 6"
From Top of Grill Opening to Ceiling: 17"
From Fuel Door to Combustion Mantel: 21"
From Fuel Door to Side Wood Mantel: 10"
From Side of Fuel Opening to Adjacent Wall: 24"
From Top Slab to Wooden Header: 12"
YOU MUST Cover Top Slab w/ 6" Non-Faced Fiberglass Insulation
From Wooden Header to Chimney Block: 2"
From 10" Stack Pipe to Bottom of Top Slab: 1"
Always
consult the installation manual for venting requirements
CHIMINEY
TERMINATION
10", HT, Class "A", 2100 , Insulated Double Wall Metal Chimney OR
12" x 12" Clay Flue
Minimum Height -10'
30 Angle Maximum Offsets
Minimum 5" Offset Required w/ Recessed Mantel
OUTSIDE
AIR TERMINATION
6" Outside Air Flex Pipe for Chamber only - (included w/ unit) (connects intake air on fireplace to 6" - 30 ga. galv. pipe)
Minimum Thickness - 30 Gauge Galvanized Pipe
Elbows - Maximum - 3
Do Not Terminate to Attic or Garage
3'
Clearance Below Chimney if Terminating Beside Chase
